Fully Automatic Vat Blow Molding Machine

The fully automatic barrel blow molding machine is an automated intelligent blow molding machine. At present, the main linear two-step blow molding machine is used. The entire blow molding process is divided into preheating and blow molding

Send Inquiry

product instruction

product-4032-3024

Preheating part of the blow molding machine
The preform enters the infrared light box through the transmission chain for heating. There are two rows of horizontally arranged red line lights in the infrared light box, and the temperature of each light can be adjusted by the single-chip PLC. The temperature of the upper and lower rows of red line lights is stable and constant.

Bottle blowing
The heated preform enters the mold clamp for bottle blowing. The hot preform enters the mold clamp and is sealed. The preform is pre-blown with gas. The stretch rod at the bottom stretches the preform upward. The pre-blown gas is blown to a certain extent. Low-pressure air is blown in, and high-pressure air is blown in at the same time. The bottle is instantly formed in a short time, and the bottle blowing is completed.

characteristic

.Adopt advanced PLC control, stable performance.
.Use conveyor to automatically transport preforms.
.In the infrared preheater, the bottle rotates synchronously with the orbit, with strong penetration, good heat distribution and rapid

.High safety, each mechanical action is equipped with a safety self-locking device, when a certain process fails, the entire process will enter a safe state.
.Using cylinder drive action instead of oil pump, no pollution, low noise.

. The process is automated, with the characteristics of low cost, high efficiency, easy operation and convenient maintenance.